Shop

Home Electronics Components CNC Shield V3 Module

CNC Shield V3 Module

120.00

  • Runs on 12-36VDC
  • GRBL 0.9 compatible
  • 4-Axis support
  • Compact design
  • 2 x End stops for each axis (6 in total)
Compare

Description

CNC Shield V3 module allows you to build a engraving machine, 3D printer, mini CNC and other similar devices using your Arduino. It is designed as a shield and can plug on top of an Arduino requiring no external connections and wiring.

There are 4 slots on the CNC Shield V3 Module board for plugging in stepper motor drive module which can drive 1 stepper motor each. Controlling each step stepper motor requires only two IO pins on the Arduino. Just insert this Arduino CNC Shield V3.0 onto an Arduino UNO, and install the GRBL firmware, you can then quickly build a DIY CNC engraving machine.

  • GRBL 0.9 compatible (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals)
  • 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using
    pins D12 and D13)
  • 2 x End stops for each axis (6 in total)
  • Coolant enable
  • Uses removable A4988 compatible stepper drivers. (A4988, DRV8825 and others)(Not Included)
  • Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do
    up to 1/32 micro-stepping )
  • Compact design.
  • Stepper Motors can be connected with 4-pin Molex connectors or soldered in place.
  • Runs on 12-36VDC. (At the moment only the DRV8825 drivers can handle up to 36V so please
    consider the operation voltage when powering the board)

Reviews

There are no reviews yet.

Be the first to review “CNC Shield V3 Module”

Your email address will not be published. Required fields are marked *

Cart

Your Cart is Empty

Back To Shop